Download Free Word & PDF Label Printing Templates for Product LP65/38

• Rectangles with rounded corners
• Centralized layout
• Selvedge present
• Bleed not possible
• Feed direction not indicated
• Gaps between labels (horizontal only

Special Feature : 

• Recycled White Rounded Labels

Please note that this label size is sometimes manufactured with a horizontal pitch that is more than 40.6 mm. If you find that your design is printing out slightly too small for your labels (i.e. if your design doesn’t start at the left edge of the first label in each row and end at the right edge of the last label in each row), you may want to try using our alternative templates (these templates are set up with a horizontal pitch of 40.8 mm). If you wish to make your own adjustments to the template you are using, remember you will also need to adjust the side margins to accommodate for using the larger horizontal pitch.

[If you are working in the landscape the horizontal pitch becomes the vertical pitch; so if your design doesn’t start at the top of the first label in each column and end at the bottom of the last label in each column, you may need to try using the “alternative” template. If you make your own adjustments, you need to remember to alter the top margin.]

Please note that these labels are sometimes cut to a label height that is very slightly under 21.2 mm. If you find that your design is printing out slightly too big for your labels (i.e. the bottom of your printed template finishes just below the bottom edge of the last label on the sheet), you may wish to try adjusting the label height to 21.1 mm. You will also need to increase the top margin to accommodate for using the smaller label height.

[If you are working in the landscape the height becomes the width; so if your design doesn’t start at the left edge of the first label in each row and end at the right edge of the last label in each row, you may need to try using 21.1 mm as the label width. Remember, you will also need to alter the side margins.] 

Please note that these templates are provided in good faith for our customers to use free of charge. Customers should test the suitability of these templates for their requirements (including compatibility with their software/hardware) and are responsible for making any necessary adjustments to achieve the best possible alignment.

All products are manufactured with a tolerance, which is an allowable deviation from the measurements stated on the goods (for example, an A4 sheet may have a tolerance of +/- 2 mm); this tolerance can lead to slight variation in the measurements of label products and so we recommend that customers complete a test print of any template before printing onto their label products so that they may determine if the template requires any further adjustments.